Try:
- Code: Select all
systemctl enable hostapd
And post result of:
- Code: Select all
systemctl status hostapd
rern
by rern » 14 Dec 2020, 15:04
systemctl enable hostapd
systemctl status hostapd
by BVLabs » 14 Dec 2020, 16:44
by BVLabs » 14 Dec 2020, 16:50
by ray1112 » 14 Dec 2020, 23:56
rern wrote:ray1112 wrote:I have Cirrus Logic Audio Card and Raspberry Pi 2.
Version e6 20201201 • RuneAudio
Hardware Raspberry Pi 2 Model B Rev 1.1
Output Device Generic Cirrus Logic WM5102
Q1. How change audio card output (Line out or Headset)? RuneAudio 0.4b have it on MPD page.
Q2. Default mixer is not working (Hardware Volume Control is not working). RuneAudio 0.4b have it working well.
If I change mixer on MPD page to "HPOUT1 Digital" I have error on MPD page:
...
On RuneAudio 0.4b, post results:
- Code: Select all
cat /boot/config.txt
aplay -l
aplay -L
amixer -c 0 scontents
amixer -c 1 scontents
amixer -c 2 scontents
rern
by amonduulii » 15 Dec 2020, 04:59
by BVLabs » 15 Dec 2020, 07:50
rern wrote:@BVLabs,
Try:
- Code: Select all
systemctl enable hostapd
And post result of:
- Code: Select all
systemctl status hostapd
rern
by rern » 15 Dec 2020, 12:51
sed -i '/Unit/ a\After=startup.service' /etc/systemd/system/hostapd.service.d/override.conf
systemctl daemon-reload
by BVLabs » 15 Dec 2020, 16:23
rern wrote:@BVLabs,
Please try:
- Remove those added lines in startup.sh
- Run:
- Code: Select all
sed -i '/Unit/ a\After=startup.service' /etc/systemd/system/hostapd.service.d/override.conf
systemctl daemon-reload
- Reboot
rern
by Sonic » 17 Dec 2020, 00:21
bink wrote:
rune interface looks nice on my newly built raspberry pi streamer.
by joe63 » 18 Dec 2020, 15:29
support RuneAudio