RuneAudio 0.4-beta for Raspberry Pi2/3

[Airstone]

Hello! Is it possible to install 0.4 beta version above 0.3 beta without removal old one and with keeping previous settings? Thanks.

[Ancipital]

Hello! Is it possible to install 0.4 beta version above 0.3 beta without removal old one and with keeping previous settings? Thanks.

See the answer on the first page of this thread:

runeaudio-0-4-beta-for-raspberry-pi2-3-t4434.html#p19971

[luamiennam]

Hello, I can't config ip for my usb wifi ( LAN & Wifi onboard on ).
Sorry, my english is not good.

[vbondarev]

Any news about read-only system?

[hondagx35]

Hello, I can't config ip for my usb wifi ( LAN & Wifi onboard on ).
Sorry, my english is not good.

Hi,

it is not possible to use more than one wifi at the moment, so you should disable the onboard wifi first.
http://www.runeaudio.com/forum/post20467.html

Frank

[luamiennam]

Hello, I can't config ip for my usb wifi ( LAN & Wifi onboard on ).
Sorry, my english is not good.

Hi,

it is not possible to use more than one wifi at the moment, so you should disable the onboard wifi first.
http://www.runeaudio.com/forum/post20467.html

Frank

Thanks .
I have a question: when using AP (wifi on board), I must have to attach the cable to the LAN port?

[Kilgore]

This may be a dumb question, but...........

If I select an I2S kernel module (for example HiFiBerry Digi/Digi+), and then reboot, should it list in the MPD 'Audio Output Interface', even if the board (+Digi+ Pro) is faulty or disconnected?

I ask because it was all working OK until a day ago when I took my setup apart to implement some power supply changes. I powered up and now I have no output from the digi+. (I have USB output from the Pi and this works OK in my DAC, so the Pi is OK)

I have downloaded the latest rune 0.4 beta image from Franks Google Drive today and reloaded my SD card, but although I have tried selecting the Digi in the I2s Settings, it doesn't list in MPD output interface dropdown. it is not clear to me if perhaps I have busted my digi+ so it does not list.....or if there is some setting I am missing.

[hondagx35]

Hi Kilgore,

If I select an I2S kernel module (for example HiFiBerry Digi/Digi+), and then reboot, should it list in the MPD 'Audio Output Interface', even if the board (+Digi+ Pro) is faulty or disconnected?

This depends on the selected driver!
The HifiBerry Digi/Digi+ needs to be attached and recognized by the driver to show up on the mpd outputs.

Frank

[Ancipital]

Do you see the Digi if you ssh in and type:

Code: Select all

aplay -l

If the module is loaded and the hardware working, it will show up there- if it doesn't, then that's where to start looking. If you can't see the module loaded when you type:

Code: Select all

lsmod | grep hifiberry

..that might be relevant too.

Edit:

Ninja-ed by frank

[hondagx35]

I have a question: when using AP (wifi on board), I must have to attach the cable to the LAN port?

No, you don't!

But if you like to play music from network storage you need a separate network connection (ethernet).

You can use wlan0 and wlan1 together, but it can not be configured from Rune UI.
Manual configuration shouldn't be hard,

Frank