Rune audio WLAN connection

abrady

hi there,

I was able to connect to the pi via an ethernet connection (eth0). I hooked up a usb dongle and was able to connect that way as well (wlan0).

When i disconnect eth0 i am unable to connect via wlan0. I have rebooted with wlan0 connected with eth0 disconnected, etc, etc.

I can however plug in eth0 and it automatically works.

i have hooked up a monitor while wlan is connected and have done the following:

systemctl enable netctl-auto@wlan0.service
systemctl enable netctl-ifplugd@eth0.service
netctl stop wlan0
netctl start wlan0

which allows me to then connect without eth0 connected.

reboot

After a reboot however it will not auto connect to wlan0 and almost stay in a loop looking for eth0 to connect. I need to log back in and restart netctl wlan0.

Help?

hondagx35

Hi abrady,

systemctl enable netctl-auto@wlan0.service
systemctl enable netctl-ifplugd@eth0.service
netctl stop wlan0
netctl start wlan0

You can't use netctl and netctl-auto at the same time.

Please try:

- systemctl disable netctl-auto@wlan0.service
- netctl enable wlan0
- reboot

For netctl-auto@wlan0.service you need a different profile.

Frank