Prevent from LED flashing constantly

Fif91

Hi,
Using the last runeaudio image (0.4b), the LED is flashing constantly.
And, still on when i poweroff the raspberry pi.

For the old version, i was following the steps from this link, to prevent from led flashing.
=> http://forum.audiophonics.fr/viewtopic.php?f=12&t=1620

Is is possible to integrate this feature in the next release ?
The steps don't seem to work well with the last version

hondagx35

Hi,

should be easy to do.

On a Pi2 add

dtparam=act_led_trigger=none
dtparam=pwr_led_trigger=none

to your config.txt

See /boot/overlays/README for more details:

act_led_trigger Choose which activity the LED tracks.
Use "heartbeat" for a nice load indicator.
(default "mmc")

act_led_activelow Set to "on" to invert the sense of the LED
(default "off")
N.B. For Pi3 see pi3-act-led overlay.

act_led_gpio Set which GPIO to use for the activity LED
(in case you want to connect it to an external
device)
(default "16" on a non-Plus board, "47" on a
Plus or Pi 2)
N.B. For Pi3 see pi3-act-led overlay.

pwr_led_trigger
pwr_led_activelow
pwr_led_gpio
As for act_led_*, but using the PWR LED.
Not available on Model A/B boards.

And for the Pi3

Name: pi3-act-led
Info: Pi3 uses a GPIO expander to drive the LEDs which can only be accessed
from the VPU. There is a special driver for this with a separate DT
node, which has the unfortunate consequence of breaking the
act_led_gpio and act_led_activelow dtparams.
This overlay changes the GPIO controller back to the standard one and
restores the dtparams.
Load: dtoverlay=pi3-act-led,<param>=<val>
Params: activelow Set to "on" to invert the sense of the LED
(default "off")

gpio Set which GPIO to use for the activity LED
(in case you want to connect it to an external
device)
REQUIRED

Frank

Fif91

Thanks Franck, but nothing I understand.
Which Params should I put in config.txt for a pi3?

The behaviour I had from the above link was :
- the led switch on and off until the system boot,
- after the led was constantly on
- if I shutdown the pi, the led switch on and off during the poweroff state and finished to switch off

Will I get this behaviour?