Installation of external button on GPIO SHUTDOWN RUNE

andre_chang

hello everyone
I am currently using 0.3BATA RUNE
but I want to use the external button to turn 2+ PI off

I tried to install a lot of ways on the forum, but it was still not a success.
It has been a problem for me for a week.
First of all,
I refer to the: #636
The following way:

1.
Synch the listing with the repositories:
pacman -Sy

2.
Install python:
pacman -S python

3.
Select gcc from the resulting list. (mine was no.10 on the list):
pacman -S base-devel

4.
wget https://pypi.python.org/packages/source/R/RPi.GPIO/RPi.GPIO-0.5.8.tar.gz

5.
unzip the tar:
tar -xvzf RPi.GPIO-0.5.8.tar.gz

6.
Install RPi.GPIO:
cd RPi.GPIO-0.5.8
python setup.py install

The above process - the installation is completed
Next, I can't go on... Because I don't know the why script can be executed automatically shutdown - h now < -- this directive defines the button is pressed

I have seen http://www.forum-raspberrypi.de/Thread-tutorial-hoch-und-runterfahren-mittels-taster-incl-status-led

This information, but unfortunately the beginning of the order: apt-get update sudo is not successful, it is clear that this may not be a viable approach

Also referred to: http://www.raspberry-pi-geek.com/Archive/2013/01/Adding-an-On-Off-switch-to-your-Raspberry-Pi

Within the code, but also no success

For Linux I am a complete novice.. but I can skillfully master the basis of electronic parts and welding

How do I continue? Please give me a detailed down the operation process. And the control button circuit diagram

Distress in ~ ~

CHANG ANDRE

hondagx35

Hi CHANG ANDRE,

I have seen http://www.forum-raspberrypi.de/Thread- ... status-led

You have already installed all necessary dependencies, so you can skip the part "I. Vorbereitung"
and start with part "II. Software".

To start the script at boot you have to use a systemd service
http://superuser.com/questions/552081/how-to-start-python-program-at-boot-on-arch-linux-arm

Frank

andre_chang

THANK YOU Frank ^_^