RuneAudio Forum

oke i really don't understand what happend here but while i was checking the stuff out you asked for and about it suddenly started to work.
t appeared in the list and the wheel (of fortune) spun and there was the entire list.

but the auto mount was already on and the debug info i couldn't find still not.. but it works.

hapy about that it works but not happy that i don't understand why, now i still wouldn't know what to fix would it happen again.

but anyway that's it and now i'll go and work on my box for the RPI. incl drive and battery.

thanks for your help!

I would to say big thank you to creators of RuneAudio and people from this thread to explain how setup Audiophonics DAC. It works like a charm !


Although, I have couple of questions regarding the ES9023 board:

1. There is 5V power outlet on it. Is it worth connecting a separate power there or is the power that it gets via I2S is enough ?
Will this improve sound quality ?

2. My ES9023 is v2 and apparently has TXCO clock. Is it worth driving it off a different clock ?

One more question,

does hardware volume control work with HiFiBerry DAC ?

I can select it in MPD settings, but then I cant change volume in Web UI, even if I put 0, the sound volume remains the same.

otec wrote:One more question,

does hardware volume control work with HiFiBerry DAC ?

The first HiFiBerry DAC didn't allow hardware volume control:
https://www.hifiberry.com/dac-faq/
while the most recent HiFiBerry DAC+ does.

ACX wrote:

otec wrote:One more question,

does hardware volume control work with HiFiBerry DAC ?

The first HiFiBerry DAC didn't allow hardware volume control:
https://www.hifiberry.com/dac-faq/
while the most recent HiFiBerry DAC+ does.

I'm actually using Audiophonics Sabre ES9023 DAC. After reading this thread, people advised enable HiFiBerry DAC driver in config.txt and MPD.

Will this DAC work with HiFiBerry DAC+ driver ?

Tried enabling HiFiBerry DAC+ driver in config.txt and upon reboot I couldnt select device in MPD list and there were some errors in dmesg.

I guess it doesnt work.

Hi,

I have a RPI3, running the latest rune audio image for rpi 3, and the Audiophonics DAC referred to above.

I have the following problem:
- I uncommented the 2 following lines in /boot/config.txt:

Code: Select all

dtparam=i2s=on
dtoverlay=hifiberry-dacplus


- I disabled the pi's analog audio out,
- I restarted the pi,
- I logged back in to the RuneUI, but nothing shows up in the audio interface list...

Running a lsmod shows the following:

Code: Select all

Module                  Size  Used by
brcmfmac              187227  0
brcmutil                8240  1 brcmfmac
cfg80211              476512  1 brcmfmac
snd_soc_pcm512x_i2c     2378  0
snd_soc_pcm512x        18481  1 snd_soc_pcm512x_i2c
regmap_i2c              2864  1 snd_soc_pcm512x_i2c
snd_soc_hifiberry_dacplus     4292  0
snd_soc_hifiberry_dac     2690  0
snd_soc_bcm2708_i2s     6965  0
i2c_bcm2708             5776  0
regmap_mmio             3193  1 snd_soc_bcm2708_i2s
bcm2835_gpiomem         3522  0
snd_soc_core          158424  4 snd_soc_pcm512x,snd_soc_hifiberry_dac,snd_soc_hifiberry_dacplus,snd_soc_bcm2708_i2s
bcm2835_rng             2031  0
snd_compress            8154  1 snd_soc_core
snd_pcm_dmaengine       5232  1 snd_soc_core
snd_pcm                86717  5 snd_soc_pcm512x,snd_soc_core,snd_soc_hifiberry_dac,snd_pcm_dmaengine,snd_soc_hifiberry_dacplus
snd_timer              21835  1 snd_pcm
snd                    62709  4 snd_soc_core,snd_timer,snd_pcm,snd_compress
clk_hifiberry_dacpro     2336  0
uio_pdrv_genirq         3343  0
uio                     9033  1 uio_pdrv_genirq
sch_fq_codel            7328  3
bcm2708_rng             1171  0
rng_core                8022  2 bcm2835_rng,bcm2708_rng
ip_tables              12167  0
x_tables               16543  1 ip_tables
ipv6                  356958  0

A dmesg shows the following errors (listed errors only):

Code: Select all

[    5.443774] snd-rpi-hifiberry-dacplus sound: ASoC: CODEC DAI pcm512x-hifi not registered
[    5.443787] snd-rpi-hifiberry-dacplus sound: snd_soc_register_card() failed: -517
[    5.482899] pcm512x 1-004d: Failed to reset device: -5
[    5.482988] pcm512x: probe of 1-004d failed with error -5
[    5.601253] snd-rpi-hifiberry-dacplus sound: ASoC: CODEC DAI pcm512x-hifi not registered
[    5.601268] snd-rpi-hifiberry-dacplus sound: snd_soc_register_card() failed: -517
[    5.604744] brcmfmac: brcmf_sdio_drivestrengthinit: No SDIO Drive strength init done for chip 43430 rev 1 pmurev 24
[    5.605141] snd-rpi-hifiberry-dacplus sound: ASoC: CODEC DAI pcm512x-hifi not registered
[    5.605149] snd-rpi-hifiberry-dacplus sound: snd_soc_register_card() failed: -517


Any help appreciated !

Thanks,

Guillaume

Hi guillaumesej,

guillaumesej wrote:- I uncommented the 2 following lines in /boot/config.txt:

dtparam=i2s=on
dtoverlay=hifiberry-dacplus

Where did you read this?

The only thing you have to do is this.
Frank

guillaumesej wrote:Hi,

I have a RPI3, running the latest rune audio image for rpi 3, and the Audiophonics DAC referred to above.

I have the following problem:
- I uncommented the 2 following lines in /boot/config.txt:

Code: Select all

dtparam=i2s=on
dtoverlay=hifiberry-dacplus


- I disabled the pi's analog audio out,
- I restarted the pi,
- I logged back in to the RuneUI, but nothing shows up in the audio interface list...

Running a lsmod shows the following:

Code: Select all

Module                  Size  Used by
brcmfmac              187227  0
brcmutil                8240  1 brcmfmac
cfg80211              476512  1 brcmfmac
snd_soc_pcm512x_i2c     2378  0
snd_soc_pcm512x        18481  1 snd_soc_pcm512x_i2c
regmap_i2c              2864  1 snd_soc_pcm512x_i2c
snd_soc_hifiberry_dacplus     4292  0
snd_soc_hifiberry_dac     2690  0
snd_soc_bcm2708_i2s     6965  0
i2c_bcm2708             5776  0
regmap_mmio             3193  1 snd_soc_bcm2708_i2s
bcm2835_gpiomem         3522  0
snd_soc_core          158424  4 snd_soc_pcm512x,snd_soc_hifiberry_dac,snd_soc_hifiberry_dacplus,snd_soc_bcm2708_i2s
bcm2835_rng             2031  0
snd_compress            8154  1 snd_soc_core
snd_pcm_dmaengine       5232  1 snd_soc_core
snd_pcm                86717  5 snd_soc_pcm512x,snd_soc_core,snd_soc_hifiberry_dac,snd_pcm_dmaengine,snd_soc_hifiberry_dacplus
snd_timer              21835  1 snd_pcm
snd                    62709  4 snd_soc_core,snd_timer,snd_pcm,snd_compress
clk_hifiberry_dacpro     2336  0
uio_pdrv_genirq         3343  0
uio                     9033  1 uio_pdrv_genirq
sch_fq_codel            7328  3
bcm2708_rng             1171  0
rng_core                8022  2 bcm2835_rng,bcm2708_rng
ip_tables              12167  0
x_tables               16543  1 ip_tables
ipv6                  356958  0

A dmesg shows the following errors (listed errors only):

Code: Select all

[    5.443774] snd-rpi-hifiberry-dacplus sound: ASoC: CODEC DAI pcm512x-hifi not registered
[    5.443787] snd-rpi-hifiberry-dacplus sound: snd_soc_register_card() failed: -517
[    5.482899] pcm512x 1-004d: Failed to reset device: -5
[    5.482988] pcm512x: probe of 1-004d failed with error -5
[    5.601253] snd-rpi-hifiberry-dacplus sound: ASoC: CODEC DAI pcm512x-hifi not registered
[    5.601268] snd-rpi-hifiberry-dacplus sound: snd_soc_register_card() failed: -517
[    5.604744] brcmfmac: brcmf_sdio_drivestrengthinit: No SDIO Drive strength init done for chip 43430 rev 1 pmurev 24
[    5.605141] snd-rpi-hifiberry-dacplus sound: ASoC: CODEC DAI pcm512x-hifi not registered
[    5.605149] snd-rpi-hifiberry-dacplus sound: snd_soc_register_card() failed: -517


Any help appreciated !

Thanks,

Guillaume

Don't uncomment dtparam=i2s=on ! In my case, when I did this, Runeaudio won't detect the I2S DAC.

Hi,

I am new on this forum so Hello !

Dose any one now can this DAC work on RPi 3 b http://www.ebay.com/urw/write-review/14 ... 1572582020.

I tried to connect but without sucess.

Thanks