RuneAudio Forum

Hi all,

First of all thanks for this great job.

I'm using RuneOS v0.3-beta on Raspberry PI Model B. I have succesfuly installed OS and booted up the board. I login from console and assign a static ip over shell. Then i connected from web interface and set static ip address from the web interface also.

When i reboot the board it will not get an ip address during boot. When i login from console i see that eth0(I'm using wired network) is not configured. Could you help me pls.

Thanks in advance

Hi nneverr,

please read this and update to the latest version.

Frank

nneverr wrote:Hi all,

First of all thanks for this great job.

I'm using RuneOS v0.3-beta on Raspberry PI Model B. I have succesfuly installed OS and booted up the board. I login from console and assign a static ip over shell. Then i connected from web interface and set static ip address from the web interface also.

When i reboot the board it will not get an ip address during boot. When i login from console i see that eth0(I'm using wired network) is not configured. Could you help me pls.

Thanks in advance

Don't know if you went after the upgrade recommended by others or not? I was on v0.4 for almost 4 years, but migrated over to rAudio last fall. I have a hardwired ethernet connection as well, but I let my router assign a DCHP since that is how it handles the rest of the network. Double check your router's settings, if it is DCHP and you are assigning a static IP on the PI I think the two might be fighting each other. I know the static IP is technically better, but my router does a pretty good job of handing out the same IP assignments under DCHP once the device has been on the network a while.