CrivenS wrote:Greetings,
I'm having problems haven't managed to successfully boot yet, and I have tried both available images on two different SD cards (a 64 and a 32) using usb image tool:
RuneAudio_rpi2_rp3_0.4-beta_20160321_2GB
&
RuneAudio_ODROIDC2_0.4-beta_20160518_2GB
I've never yet seen even a flicker of green from the pi to indicate SD reading. and only had the rainbow screen on hdmi.
I have successfully had M2P, Moode and Volumio run from each card as well to test.
Kind of at my wits end. Any suggestions would be appreciated.
Hi Criven
Well odroidc2 wont work as that is a different SBC also the images you mentioned are not 0.5 as 0.5 is an unofficial update to rune audio. If you want to use 0.5 for your 3b+ you need to get it from here:
http://www.mediafire.com/file/16d92z7jb ... mg.gz/fileIf you go to page 1 of this thread it will give you all the information from the creator.
I would recommend using Win32DiskImager as I have never had an issue when writing to SD cards because the errors you are describing you don't get past the rainbow screen and nothing from the activity LED sounds like the image was not written to the SD card correctly:
Win32DiskImager
-Insert the SD card into your SD card reader. You can use the SD card slot if you have one, or an SD adapter in a USB port. Note the drive letter assigned to the SD card. You can see the drive letter in the left hand column of Windows Explorer, for example G:
-Download the Win32DiskImager utility from the Sourceforge Project page as an installer file, and run it to install the software.
-Run the Win32DiskImager utility from your desktop or menu.
-Select the image file you extracted earlier.
-In the device box, select the drive letter of the SD card. Be careful to select the correct drive: if you choose the wrong drive you could destroy the data on your computer's hard disk! If you are using an SD card slot in your computer, and can't see the drive in the Win32DiskImager window, try using an external SD adapter.
-Click 'Write' and wait for the write to complete.
-Exit the imager and eject the SD card.