RuneAudio Forum

I am going to do this same mod to Compute CM3L module, I am using the Geekworm IO board. I've looked at the schematic for the official evaluation board but mine is a little different, is there anyone here who could help me out, what needs to be removed and where to connect the regulators.

I've located the PAM2306 chip and the L1 and L2 inductors. The only thing that confuses me, is that there is a TPS61090 on the same area near the inductors, anyone have any idea is it on the 3.3V or 1.8V supply? If i just remove the inductors and use those pads as input for the new supplies, is that okay? And should I remove the PAM2306 or do I need to renomove the TPS61090 too? Or can they be left untouched if I remove the inductors?

Hi,

to make things a little bit clearer to me:

It would be better to feed the Pi with separate power supplies for 5V/3,3V/1,8V even if I use a DAC head with own "clean" power supply?

thx

Branko

RPi 3B+ and IQaudIO DAC+ pro

drone wrote:Hi,

to make things a little bit clearer to me:

It would be better to feed the Pi with separate power supplies for 5V/3,3V/1,8V even if I use a DAC head with own "clean" power supply?

thx

Branko

RPi 3B+ and IQaudIO DAC+ pro

Of course. And to take things even further, you could use an usb isolator with linear power supply on the way to the dac.

drone wrote:Hi,

to make things a little bit clearer to me:

It would be better to feed the Pi with separate power supplies for 5V/3,3V/1,8V even if I use a DAC head with own "clean" power supply?

thx

Branko

RPi 3B+ and IQaudIO DAC+ pro

Have a look on Singxer UIP 1. You can find the subject on a forum.