I received the Sabre ES9023 DAC board yesterday that I tried with C2 / Rune.
The detail pins connection (as above picture from top down) to C2 (pin 1 as marked from left to right as pin 7) are:
MCLK : skipped, not connected
GND : skipped, not connected
DATA : to C2 / pin 7
LRCK : to C2 / pin 5
BCK : to C2 / pin 6
5V : to C2 / pin 3
GND : to C2 / pin 1
The C2 / Rune was started up that I went into ssh to run following commands:
- Code: Select all
set_rw
nano /boot/boot.ini
... added in the line
- Code: Select all
setenv enabledac "enabledac"
...saved
- Code: Select all
set_ro
reboot C2/Rune but I don't see ODROID-DAC appeared in MPD so there is no sound out when playing.
Has anyone else tried it yet? Please advise / correct me. Thanks.
@hondagx35: your support is highly appreciated. Thanks.
Notes:
1) The above code I referred from http://forum.odroid.com/viewtopic.php?t=15741
2) Where I bought the dac board: http://s.aliexpress.com/RvEZRB3M